OSHA Safety Practice Test: Hazard Recognition and Worker Rights
- Hazard Recognition and Worker Rights
- 10 questions
- 13 minutes
Ten questions on spotting hazards, choosing the best control and knowing your rights at work. Tip: when a question asks for the best way to control a hazard, think of removing it first and protecting the worker last.
Tap an option to mark your answer. You can change your mind, or tap the same option again to leave the question blank. The correct answers and explanations appear when you finish the test.Tap an option to answer; tap it again to leave the question blank.
Your result
- 0 correct
- 0 wrong
- 0 blank
-
Question 1
Which of these is the most effective way to control a workplace hazard, according to the hierarchy of controls?
Correct answer: A
Elimination removes the hazard entirely. PPE is last on the list because it protects only the person wearing it and relies on proper use.
-
Question 2
A shop replaces a solvent that gives off harmful fumes with a safer cleaner. Which level of the hierarchy of controls is this?
Correct answer: C
Replacing a hazardous material with a less hazardous one is substitution. An engineering control would instead isolate the worker from the hazard, such as ventilation.
-
Question 3
Which of these is an engineering control?
Correct answer: D
Engineering controls are built into the equipment or workspace and work without the worker having to remember anything.
-
Question 4
Which statement describes a worker's right under the Occupational Safety and Health Act?
Correct answer: B
Workers can ask OSHA to inspect the workplace and can ask that their name not be given to the employer. They cannot refuse tasks simply because they dislike them.
-
Question 5
What is the purpose of a job hazard analysis?
Correct answer: A
A job hazard analysis looks at each step of a task before anyone is hurt so the hazards can be removed or controlled.
-
Question 6
An employer disciplines a worker for reporting a safety concern to OSHA. What does the OSH Act say about this?
Correct answer: B
Employers may not punish workers for exercising their safety rights. A worker who faces retaliation should contact OSHA promptly, because filing deadlines are short.
-
Question 7
Which of these is an example of a near miss?
Correct answer: D
A near miss is an event that could have caused injury but did not. Reporting and investigating near misses can prevent real injuries.
-
Question 8
An employer must report to OSHA when a worker is killed on the job. Within how many hours of learning of the death?
Correct answer: C
A work-related death must be reported within 8 hours. A hospitalization, amputation or loss of an eye must be reported within 24 hours.
-
Question 9
Which situation is a hazard that should be fixed immediately?
Correct answer: A
Slippery surfaces cause slips and falls, which are among the most common workplace injuries. The other items show hazards already controlled.
-
Question 10
In construction, what are the most frequent causes of fatal injuries, often called the "Fatal Four"?
Correct answer: D
Falls cause the most deaths, followed by struck-by incidents; electrocution and caught-in or between incidents make up the rest of the group, which OSHA now calls the Focus Four.
Questions you leave blank are not counted as wrong.