OSHA Safety Practice Test: Fall and Electrical Hazards
- Fall and Electrical Hazards
- 10 questions
- 13 minutes
Ten questions on preventing falls and electrical injuries. Tip: for electrical questions, think about where the current could go, and for fall questions, think about height, edges and anchor points.
Tap an option to mark your answer. You can change your mind, or tap the same option again to leave the question blank. The correct answers and explanations appear when you finish the test.Tap an option to answer; tap it again to leave the question blank.
Your result
- 0 correct
- 0 wrong
- 0 blank
-
Question 1
In construction, at what height above a lower level must employers generally protect workers from falls?
Correct answer: B
OSHA's construction standards generally require fall protection at 6 feet. General industry uses 4 feet.
-
Question 2
Which is a type of fall protection that stops a worker who has already fallen?
Correct answer: D
A harness, lanyard and anchor catch the worker after a fall begins. A guardrail aims to prevent the fall in the first place.
-
Question 3
When using a portable ladder, how many points of contact should you keep?
Correct answer: A
Keep two hands and one foot or two feet and one hand on the ladder when climbing. This keeps your balance if one limb slips.
-
Question 4
A straight ladder is set against a wall. About how far should the base be from the wall for every 4 feet of height to the support?
Correct answer: C
The 4-to-1 rule says to place the base one foot out for every four feet up. A ladder that is too steep can fall backward and one that is too shallow can slide out.
-
Question 5
How far should the side rails of a ladder extend above a landing when climbing onto a roof?
Correct answer: B
At least 3 feet of extension gives you something to hold as you step on and off.
-
Question 6
What is the job of a ground-fault circuit interrupter (GFCI)?
Correct answer: A
A GFCI senses a small imbalance in current and cuts power in a fraction of a second. This can prevent electrocution, especially in wet places.
-
Question 7
A worker finds a power cord with its insulation frayed and wires showing. What should the worker do?
Correct answer: D
Damaged cords must be removed from service. Tape and GFCIs do not make a damaged cord safe.
-
Question 8
What is the purpose of lockout/tagout?
Correct answer: C
Lockout/tagout controls hazardous energy by isolating and locking power sources. Only the person who placed the lock should remove it.
-
Question 9
Before working near an overhead power line, what should you assume about it?
Correct answer: D
Overhead lines are usually bare, and contact can be fatal. Stay at least 10 feet away for lines up to 50 kilovolts and more for higher voltages.
-
Question 10
Why is water especially dangerous around electrical equipment?
Correct answer: A
Wet skin lets more current pass through the body. Even small currents can be harmful.
Questions you leave blank are not counted as wrong.