CDL Combination Vehicles Practice Test: Coupling and Uncoupling
- Coupling and Uncoupling
- 10 questions
- 13 minutes
Ten questions on how a tractor and trailer are joined, separated and driven safely. Tip: picture the order of steps; many questions ask what comes before or after a specific step.
Tap an option to mark your answer. You can change your mind, or tap the same option again to leave the question blank. The correct answers and explanations appear when you finish the test.Tap an option to answer; tap it again to leave the question blank.
Your result
- 0 correct
- 0 wrong
- 0 blank
-
Question 1
Before backing the tractor under a trailer, what should you check about the trailer height?
Correct answer: A
The trailer should be a little lower than the fifth wheel so the apron is lifted slightly as the coupler slides onto it. If it is too low, the tractor may strike and damage the trailer nose; if it is too high, it may not couple correctly.
-
Question 2
After coupling, how do you check that the trailer is locked onto the tractor before you rely on it?
Correct answer: C
With the trailer brakes applied, a gentle tug forward will show that the kingpin is locked in the jaws. Do not rely on the sound alone.
-
Question 3
When you check the fifth wheel connection under the trailer, what should you see?
Correct answer: B
A gap means the trailer may not be fully seated. The jaws should be locked around the kingpin, and the release arm in its secured position.
-
Question 4
Which statement describes the correct connection of the trailer air lines?
Correct answer: D
Gladhands are marked or coded so the service and emergency lines are not crossed. Check the rubber seals and make sure the connections are tight before supplying air.
-
Question 5
What should you do after you connect the air lines and before you raise the landing gear?
Correct answer: A
You need air pressure in the trailer system and the air supply valve set to supply it before the trailer brakes release. Only after the connection has been checked is the landing gear raised.
-
Question 6
Which is the correct reason to raise the landing gear fully before you drive off?
Correct answer: D
A landing gear left down can catch on bumps, curbs and crossings. Raising it fully, after supplying air and checking the connection, is part of the coupling sequence.
-
Question 7
When uncoupling a trailer, which step should you do before pulling the tractor away?
Correct answer: C
The trailer must be supported by the landing gear before the fifth wheel is released. Disconnecting lines first prevents damaging them as you pull away.
-
Question 8
What is a main danger of a tractor-trailer combination compared with a straight truck?
Correct answer: B
Higher centers of gravity and the pivot between tractor and trailer make rollovers and jackknifes more likely, especially in turns, on slippery roads and with hard braking.
-
Question 9
What commonly causes a tractor-trailer to jackknife?
Correct answer: D
When the drive wheels lock and lose traction, the trailer pushes the tractor around. Brake early and smoothly and avoid sudden steering on slippery pavement.
-
Question 10
When should you use the trailer hand valve?
Correct answer: A
Trailer hand valve air can leak off and the brakes release, so it is not for parking. Use the parking brakes and wheel chocks for that. The valve is used to check that the trailer brakes work.
Questions you leave blank are not counted as wrong.