CDL Air Brakes Practice Test: Air Brake System and Components
- Air Brake System
- 10 questions
- 13 minutes
Ten questions on how a truck air brake system builds pressure, warns you, and stops the vehicle. Tip: remember the story of air pressure: it is built, stored, applied and, when it drops too low, the spring brakes take over.
Tap an option to mark your answer. You can change your mind, or tap the same option again to leave the question blank. The correct answers and explanations appear when you finish the test.Tap an option to answer; tap it again to leave the question blank.
Your result
- 0 correct
- 0 wrong
- 0 blank
-
Question 1
What does the air compressor governor do?
Correct answer: D
The governor tells the compressor to start pumping when pressure falls to about the cut-in level (around 100 psi) and stop at the cut-out level (around 125 psi).
-
Question 2
On most vehicles the low air pressure warning must come on before the pressure in the tank drops below
Correct answer: B
A buzzer, light or both must warn you at 60 psi or higher. 20 to 45 psi is the range in which the spring brakes begin to apply, so the warning comes well before that.
-
Question 3
Why should you drain the air tanks regularly if your vehicle does not have an automatic drain?
Correct answer: A
Water and compressor oil collect in the tanks. In cold weather the water can freeze and block lines, and oil can foul the brake parts.
-
Question 4
What is the job of the spring brakes?
Correct answer: C
Heavy springs hold the brakes on when no air is pushing against them. If pressure falls to roughly 20 to 45 psi, they start to apply on their own.
-
Question 5
A truck with a dual air brake system is started with the pressure at zero. About how fast should pressure rise from 85 to 100 psi at an engine speed of 1,500 to 1,800 rpm?
Correct answer: A
A healthy compressor builds that last portion of pressure in about 45 seconds or less. A slower rise points to a leak or a worn compressor.
-
Question 6
You are testing the air leakage rate on a straight truck with a fully charged system and the engine off. You apply 90 psi or more with the brake pedal and hold. After the initial pressure drop, how much may the gauge fall in one minute?
Correct answer: D
With the service brakes applied, after the initial pressure drop, the pressure loss on a single vehicle should be no more than 3 psi in a minute (4 psi for a combination). Larger losses indicate a leak.
-
Question 7
What is brake lag in an air brake system?
Correct answer: B
It takes a fraction of a second for air to reach the brake chambers after you push the pedal. This adds to the distance needed to stop, which is why air brake vehicles take longer to stop than you might expect.
-
Question 8
What is the correct way to use the brakes when going down a long, steep grade?
Correct answer: A
The engine does most of the holding if you choose the right gear before starting down. Brakes used continuously can overheat and fade, which makes them lose stopping power.
-
Question 9
What does it mean if the brake slack adjusters move more than about one inch when you pull on them by hand?
Correct answer: C
Too much travel at the push rod means the brakes are out of adjustment and will have less stopping force. This is a common out-of-service finding.
-
Question 10
In a dual air brake system, which statement is true?
Correct answer: D
A dual system splits the brakes so that if one part fails the other still provides some braking, but you must still stop safely and have the problem fixed.
Questions you leave blank are not counted as wrong.