AP Physics 2 Practice Test: Fluids
- Fluids
- 10 questions
- 15 minutes
Ten questions on static and moving fluids. Use g = 9.8 m/s² and 1000 kg/m³ for the density of water. Tip: check units and decide first whether the fluid is at rest or flowing.
Tap an option to mark your answer. You can change your mind, or tap the same option again to leave the question blank. The correct answers and explanations appear when you finish the test.Tap an option to answer; tap it again to leave the question blank.
Your result
- 0 correct
- 0 wrong
- 0 blank
-
Question 1
What is the gauge pressure at a depth of 5.0 m in fresh water?
Correct answer: D
Gauge pressure is ρgh = (1000)(9.8)(5.0) = 4.9 × 104 Pa. Adding atmospheric pressure gives the absolute pressure, about 1.5 × 105 Pa.
-
Question 2
A solid object with a volume of 2.0 × 10-3 m³ is held completely under water. What is the buoyant force on it?
Correct answer: C
F = ρfluidVg = (1000)(2.0 × 10-3)(9.8) = 19.6 N. Slipping a decimal place gives 1.96 N or 196 N.
-
Question 3
A uniform wooden block with density 600 kg/m³ floats in water. What fraction of its volume is submerged?
Correct answer: A
At equilibrium the buoyant force equals the weight, so the submerged fraction equals the density ratio, 600/1000 = 0.60. The 40% figure is the part above the surface.
-
Question 4
Water flows steadily through a horizontal pipe whose diameter narrows from 4.0 cm to 2.0 cm. The speed in the wide part is 1.0 m/s.
What is the speed in the narrow part?
Correct answer: B
Continuity requires A1v1 = A2v2. Area depends on the square of the diameter, so halving the diameter quarters the area and quadruples the speed.
-
Question 5
An ideal fluid flows steadily through a horizontal pipe that narrows.
Compared with the wide section, the narrow section has
Correct answer: C
Continuity gives higher speed in the narrow section, and Bernoulli's equation for a horizontal pipe then requires lower pressure there.
-
Question 6
Water flows through a horizontal pipe. In the wide section the speed is 2.0 m/s and in the narrow section it is 6.0 m/s.
By how much does the pressure in the wide section exceed the pressure in the narrow section?
Correct answer: A
ΔP = ½ρ(v2² − v1²) = ½(1000)(36 − 4) = 1.6 × 104 Pa. Forgetting the ½ doubles it, and adding the squares gives 2.0 × 104 Pa.
-
Question 7
In a hydraulic lift, the small piston has an area of 0.010 m² and the large piston has an area of 0.20 m². A force of 150 N is applied to the small piston.
What is the maximum force exerted by the large piston, assuming an ideal fluid?
Correct answer: B
Pressure is transmitted equally, so F2 = F1(A2/A1) = 150(20) = 3,000 N. The force is multiplied, while the work done is not.
-
Question 8
A large tank open to the air has a small hole 3.2 m below the water surface.
What is the approximate speed of water leaving the hole? Ignore viscosity.
Correct answer: D
Torricelli's law gives v = √(2gh) = √(2 × 9.8 × 3.2) ≈ 7.9 m/s. Leaving out the factor of 2 gives 5.6 m/s.
-
Question 9
An object weighs 12 N in air and has an apparent weight of 8 N when fully submerged in water.
What is the density of the object?
Correct answer: A
The buoyant force is 12 − 8 = 4 N, so the weight is three times the buoyant force and the density is three times that of water, 3000 kg/m³. Using 12/8 gives 1500, which ignores that 8 N is only the apparent weight.
-
Question 10
Three open containers with different shapes are filled with water to the same height above flat bottoms of equal area.
How do the pressures at the bottoms compare?
Correct answer: B
Hydrostatic pressure is ρgh, with no dependence on the container's shape or total amount of water. Equal depth and equal fluid mean equal pressure.
Questions you leave blank are not counted as wrong.